User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Configuration
4-38
6700-A2-GY31-70
July 1999
Comments: An optional field for additional alert beeper information
(maximum 40 characters).
Dialing Device: An optional field that identifies the name of a local device
that will be used to dial the beeper numbers. If no device is selected, the first
available idle device is used.
5. Choose Selected Alerts to display the Select Beeper dialog box which allows
you to associate alerts with this beeper number.
6. To create an Assigned Alerts list, select the desired alerts from the Available
Alerts list, then choose Add to add them to the Selected Alerts list. Or, select
desired alerts from the Selected Alerts list, then choose Remove to delete
them from the Selected Alerts list.
7. Choose OK to close the Select Beeper Alerts dialog box and display the list
just created on the Alert Beeper Configuration input form in the Assigned
Alerts list.
8. To associate device names with this beeper number, choose Devices to open
the Device Selection List dialog box. Make your selection(s), then choose
OK. This list appears on the Alert Beeper Configuration input form in the
Assigned Devices list.
9. Choose Availability to display the Beeper Availability dialog box. This dialog
box allows you to indicate what hours of the day NMS will dial the beeper.