User`s guide
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installation
- Start-Up
- Configuration
- Displays
- Statistics
- Device Management
- Dial Function
- Firmware Download
- Reports
- Session
- Platform/Network Performance Monitor
- Hard Disk and System Recommendations
- NMS Windows Conventions
- Record and Device Locks
- Cabling Requirements
- Data Input Sheets
- Glossary
- Index
Configuration
4-58
6700-A2-GY31-70
July 1999
Units: The unit of measure for this impairment.
dBm = decibels/milliwatt
dB = decibels
Hz = Hertz
Ms = milliseconds
Lower Limit: Not available for every impairment. Using the range field, select
a value for the lower limit. Negative or positive numbers are allowed. The
lower limit must always be less than the upper limit.
Upper Limit: Not available for every impairment. Using the range field, select
a value for the upper limit. Negative or positive numbers are allowed. The
upper limit must be greater than the lower limit.
5. Select values in the Upper Limit and Lower Limit fields using the range
buttons.
6. Choose Save or one of the other commands from the Action menu
(See Table 4-1).
Purging Calls
Choose the Purge All Calls command from the System pull-down menu. Once
you purge all calls, it is recommended that you perform a complete reorganization
of your database. See Chapter 13,
Hard Disk and System Recommendations
, for
more information.
Purging Alerts
Choose the Purge Alerts command from the System pull-down menu. Once you
purge all alerts, it is recommended that you perform a complete reorganization of
your database. See Chapter 13,
Hard Disk and System Recommendations
, for
more information.