Home Security System User's Manual

38
Live
The phone call is associated to an Internet connection request.
When you need to access the Vega Wireless Camera GPRS remotely, you
only need to call the Vega Wireless Camera GPRS phone number from your
mobile phone. The camera reads the incoming phone number and compares
it to the phone numbers in the Cli Enabled configuration page. If the user is
enabled, then Vega Wireless Camera denies the call and immediately
activates an Internet connection via GPRS. Then it notifies the user
requesting it with its IP address, via a SMS message.
Alarm On Off
The phone call is associated to the camera Standby management.
The Standby function allows – with the camera on - to enable or disable the
digital inputs and to perform the alarm detection.
For example, you may disable the camera before entering home and
reactivate it when leaving it.
When the Vega Wireless Camera GPRS is active, you only need to call the
Vega Wireless Camera GPRS phone number from your mobile phone. The
camera reads the incoming phone number and compares it to the phone
numbers in the Cli Enabled configuration page. If the user is enabled, then
Vega Wireless Camera denies the call. From now on the camera will ignore
the status changes on the digital inputs and you may, for example, enter
home without receiving an alarm message by the camera.
When you go out again, to reactivate your camera you just need to behave in
the same way: you will have to call the camera that is going to detect the
phone number and deny the call again. This time, to make sure about
activation, you will receive a phone call by the camera after a few seconds:
deny the phone call by pressing the call end button on your mobile phone
(usually the red hang-up button).
To sum up:
- to disable the digital inputs, call the Vega Wireless Camera GPRS; this will
deny the call without calling back.
- to enable the digital inputs, call the Vega Wireless Camera GPRS; this will
deny the call and after a few seconds it will call you back to confirm the
operation.
Cli Enabled: in these fields you must digit the phone numbers of the users who will be allowed to manage
the phone call. The phone number should be preceded by the international prefix (e.g.
[phone]).
SMS To CLI: SMS management to confirm the operation.
Disabled The SMS message with the IP address following a Live Internet connection
request is sent to all phone numbers in the GPRS configuration page.
Enabled The SMS message with the IP address following a Live Internet connection
request is sent to the user who requested the connection and called the Vega
Wireless Camera GPRS.
WARNING: before calling the phone number of the SIM card in the Vega Wireless Camera GPRS,
check that your mobile phone is enabled to transmit your phone number. If the camera receives
an anonymous call (that is no phone number is displayed), it does not perform any operation
and only denies the call. Check with your phone company that the SIM card in the Vega
Wireless Camera GPRS is enabled to receive voice phone calls. The SIM cards with a Machine
To Machine contract are not allowed to receive voice phone calls.