Datasheet

1300 Henley Court

Pullman, WA 99163

509.334.6306

www.digilentinc.com

PmodDA2™ Reference Manual

Revised May 24, 2016

This manual applies to the PmodDA2 rev. B

DOC#: 502-113

Other product and company names mentioned may be trademarks of their respective owners.

Page 1 of 2

Overview

The PmodDA2 is a 12-bit Digital-to-Analog converter powered by the Texas Instruments DAC121S101. As it is able

to simultaneously convert two separate channels of digital information provided over an interface similar to SPI,

users can easily compare the two reconstructed signals.

1 Functional Description

The PmodDA2 provides two channels of 12-bit Digital-to-Analog conversion, allowing users to achieve a resolution

up to about 1mV.

2 Interfacing with the Pmod

The PmodDA2 communicates with the host board via an SPI-like protocol. By bringing the Chip Select line to a low

voltage state, users may send a series of 16 clock pulses on the Serial Clock line (SCLK). The data is sent out with

the most significant bit (MSB) first on the last 12 clock pulses. An example data stream of how the data might look

is provided from the TI datasheet below:

The PmodDA2.

 12-bit digital-to-analog converter

 Two simultaneous conversion channels

 Very low power consumption

 Small PCB size for flexible designs 1.0“ ×

0.8” (2.5 cm × 2.0 cm)

 6-pin Pmod connector with GPIO interface

 Library and example code available

in resource center

Features include:

PAGE 1
300 Henley Court Pullman, WA 99163 509.334.6306 www.digilentinc.com PmodDA2™ Reference Manual Revised May 24, 2016 This manual applies to the PmodDA2 rev. B Overview The PmodDA2 is a 12-bit Digital-to-Analog converter powered by the Texas Instruments DAC121S101. As it is able to simultaneously convert two separate channels of digital information provided over an interface similar to SPI, users can easily compare the two reconstructed signals.
PAGE 2
PmodDA2™ Reference Manual Figure 1. PmodDA2 data stream. Pin 1 2 3 4 5 6 Signal ~SYNC DINA DINB SCLK GND VCC Description Chip Select Data In for Channel A Data In for Channel B Serial Clock Power Supply Ground Power Supply (3.3V/5V) Table 1. PmodDA2 pinout table. Figure 2. PmodDA2 circuit diagram. Any external power applied to the PmodDA2 must be within 2.7V and 5.5V; however, it is recommended that Pmod is operated at 3.3V.