User's Manual

DCWL-7962OT Outdoor AP
Installation Manual Chapter 3 AP Installation
3-8
3.6 AP Power
3.6.1 Checking before Power
After installing the AP, user should check it before power every time as below:
 When AP use the 802.3at standard PoE power, please ensure the power is
connected normally to ground.
3.6.2 PoE Power
User can use the Ethernet cable to connect the Ethernet interface of the AP and the
switch which supports PoE function to power to the AP.
3.6.3 Checking after Power
Check if the LED of AP works normally after connecting the power. The explanation of
LED status is seen in the product spec.
3.7 Connect AP to Internet
In the actual use, AP can be uplink connected to the Internet or MAN through the
Ethernet port. Connect the Ethernet port of the AP to the switch port to achieve the uplink
connection.