Info and Install Guide

Installation Tips
Dimensions plastic lattice can be cut and drilled using standard
tools. Use rustproof or rust-resistant fasteners to maintain the
beauty of your project over time. For a distinguished look,
frame panels with plastic caps and connect panels with plastic
dividers. Always allow a 1/4" gap between the lattice edge and
moulding for the panel to expand and contract with tempera-
ture changes. Lattice must be attached to a self-supporting
structure or frame. Suspend lattice from top row of fasteners.
•
Along the top, use a 1/4" drill bit to predrill oversized holes
every two feet through both the moulding and lattice.
Fasten with screws, taking care not to over-tighten. Along
the sides and bottom, predrill oversized holes every two
feet through the moulding only and fasten with screws.
Again, be careful not to over-tighten the screws.
•
Do not install lattice in a horizontal application.
Without proper support, lattice will be prone to
sagging, rippling and heat retention.
•
Standard Dimensions lattice is a nonporous
material. Coatings such as paint and stain do not
adhere well to the surface.
Paintable Lattice Painting Tips
•
Clean the surface of the paintable plastic lattice
sheet with a solution of warm water and dish soap.
Rinse and allow to dry.
•
Apply two thick coats of an aerosol primer for plastic
*
over the entire surface, as instructed on the can.
Allow to dry between coats.
•
Once dry, apply a thin coat of any aerosol paint over
the entire surface, per product directions. Allow to
dry as directed. Apply a second coat of aerosol paint
over entire lattice sheet. Allow to dry as directed.
*
Paint for Plastic can be used without primer per product instructions.
Lifetime Limited Warranty
•
Universal Consumer Products, Inc. offers an express
limited warranty for Dimensions plastic lattice at
DimensionsDIY.com.
1/4" GAP
Add dimension to your space.
Check out our Dimensions Pinterest page for inspiration
and creative ideas on how to use lattice for an endless
number of indoor and outdoor projects.
White Privacy Diamond
White Privacy SquareClay Classic Diamond
Driftwood Gray Privacy Diamond
Paintable Classic Diamond
Black Classic Diamond
2801 East Beltline NE
•
Grand Rapids, MI 49525
•
800.556.8449
•
DimensionsDIY.com
Dimensions is a trademark of Universal Consumer Products Inc, in the U.S.
©2016 Universal Forest Products, Inc. All rights reserved. 8841_6/16