Installation Guide

6
www.dimplex.com
!
IMPORTANT: Ensure that the incoming power supply voltage matches the
setting of the voltage selector switch.
!
NOTE: The voltage selector switch is located inside the exhaust panel on
the top right hand corner.
CAUTION: When changing the voltage selector switch from 240V to 120V
ensure that the power supply is turned off.
!
NOTE: Carefully insert a at headed screwdriver inside the exhaust panel
to change the switch from 240V (230 position) to 120V (115 position).
When wiring the unit for 208V / 240V the voltage selector switch should be in
the 230V position.
When wiring the unit for 120V the voltage selector switch should be in the
115V position.
VOLTAGE SELECTOR SWITCH LOCATION