Warranty
16 www.dimplex.com
Fireplace Installation
• Plug in (you may run the
power cord out of the framed
wall opening to an existing
outlet or install an outlet on
a nearby wall stud within the
wall).
• Hard wire the replace (rec-
ommended). Follow the hard
wiring instructions on page 9.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of re,
electric shock or injury to persons,
always use a licensed electrician.
Ensure that the On/Off Switch is set
to the Off position (refer to Opera-
tion section) and that the circuit on
which the replace is to be installed
has the power cut off at the service
panel until installation is complete.
3. Lift replace and insert into
opening. The replace's
mounting trim should be ush
against the wall (Figure 14).
4. Use bubble level (supplied) to
level the replace within the
framing. Adjust as required.
5. Drive four supplied mounting
screws through the four mount-
ing holes located on the inside
surface of the replace chas-
sis, into wall studs (Figure 14).
6. Refer to Front Glass Installa-
tion section, page 17 for nal
installation procedures.
Figure 15
Front tray
Front glass
assembly
Figure 14
Mounting hole
Mounting hole
Wall
surface