Operation Manual

DRAINAGE IN HIGH HUMIDITY CONDITIONS -

AND STORAGE ONLY

During the process of cooling, water will be generated from the air and collected in the

water tank inside the unit.When the tank is full, the compressor will stop and the Full

Water indicator on the control panel will come on to remind you to empty

the water tank. During this time the fan

will continue to operate circulating the air.

The water tank should be emptied as

follows:

1. Turn off the unit.

2. Position the supplied plastic water tray,

flat on the floor, under the drain hole.

3. Remove the water stopper and the

rubber plug. Empty the condensed

water from the air conditioner.

4. When the water tray is almost full,

replace the rubber plug to stop the

flow of water, empty the water tray.

5. Repeat step 2, 3, 4, till all the condensed

water is emptied.

6. After all condensed water is drained,

replace the rubber plug and water

stopper.

The FULL WATER indicator should be off now.

ATTENTION!

1. All condensed water must be drained prior to relocation or storage.

Water stopper

Rubber

plug

Water

tray

Dimplex DAC12005_9005.qxd 7/5/05 3:34 PM Page 9

Downloaded from www.Manualslib.com manuals search engine