Owner’s Manual Model DF2024L DF2024CR 6908891459 6908891559 IMPORTANT SAFETY INFORMATION: Always read this manual first before attempting to install or use this fireplace. For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.
Table of Contents Welcome & Congratulations. . . . . . . . . . . . . . . . . 3 IMPORTANT INSTRUCTIONS . . . . . . . . . . . . . . . 4 Fireplace Installation . . . . . . . . . . . . . . . . . . . . . . . 7 Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Maintenance. . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Replacement Parts. . . . . . . . . . . . . . . . . . . . . . . .
Welcome & Congratulations Thank you and congratulations for choosing to purchase an electric fireplace from Dimplex, the world leader in electric fireplaces. Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty.
IMPORTANT INSTRUCTIONS When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: ① Read all instructions before using this heater. ② This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. The trim around the heater outlet becomes hot during heater operation. WARNING: High temperatures may be generated under certain abnormal conditions.
IMPORTANT INSTRUCTIONS where it will be exposed to flammable vapors. ⑮ Do not burn wood or other ⑬ Do not modify the heater. ⑯ Do not strike the front glass. ⑰ Always use a certified Use it only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. ⑭ To reduce the risk of electric shock, this heater has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way.
IMPORTANT INSTRUCTIONS WARNING: Remote control contains a small battery. Keep away from children. If swallowed, seek medical attention immediately. WARNING: Do not install battery backwards, charge, put in fire or mix with used or other battery types - may explode or leak causing injury. ! NOTE: Changes or modifications not expressly approved by the party responsible for compliance could void user's authority to operate the equipment.
Fireplace Installation WARNING: Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure that the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire, electric shock or injury to persons. WARNING: Construction and electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electric shock and injury to persons.
Fireplace Installation place for securing and using the provided L-bracket and the screw that was removed attach the firebox to the mantel. (Figure 2) ! NOTE: There are no guide holes provided for the L-Brackets in the mantel. If not installing the unit into a Dimplex mantel the required opening dimensions of the fireplace are: 21 ¼ in. (540 mm) wide x 21 ⅝ in. (550 mm) high x 7 ¼ in. (184 mm) deep (Figure 3).
Operation Figure 4 Figure 5 A A B C F C F D E B F C On Screen Display The unit can be controlled by either the manual controls which are located on the upper right of the fireplace or the remote (Figure 4 & 5). A. Standby Turns the unit On and Off. → Activated by pressing the Standby button on the remote or the unit. • The unit will turn on with the same functions that it was set to when it was turned Off and the intake temperature will be indicated on the On Screen Display.
Operation the unit is only running with the heater, the icon and the intake temperature will continuously be displayed on the On Screen Display. ! NOTE: The heater may emit a slight, harmless odor when first used. This odor is a normal condition caused by initial heating of internal heater parts and will not occur again. D & E. Thermostat Controls Adjusts the temperature set point to your individual requirements. Once the desired set temperature is reached the heater will turn off.
Operation pressing the button repeatedly until the sleep timer displays nothing. Resetting the Temperature Cutoff Switch Should the heater overheat, an automatic cut out will turn the heater off and it will not come back on without being reset. It can be reset by unplugging the unit and waiting 5 minutes before plugging the unit back in. CAUTION: If you need to continuously reset the heater, unplug the unit and call technical support at 1-888-346-7539. Remote Control Battery Replacement 1.
Maintenance WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons. Glass Cleaning The glass is cleaned in the factory during the assembly operation. During shipment, installation, handling, etc., the front glass panel may collect dust particles; these can be removed by dusting lightly with a clean dry cloth. To remove fingerprints or other marks, the front glass panel can be cleaned with a damp cloth.
Warranty One Year Limited Warranty Products to which this limited warranty applies This limited warranty applies to your newly purchased Dimplex electric fireplace. This limited warranty applies only to purchases made in any province of Canada except for Yukon Territory, Nunavut, or Northwest Territories or in any of the 50 States of the USA (and the District of Columbia) except for Hawaii and Alaska. This limited warranty applies to the original purchaser of the product only and is not transferable.
Warranty • Dimplex will in its sole discretion either repair or replace such defective product or part without charge. If Dimplex is unable to repair or replace such product or part, or if repair or replacement is not commercially practicable or cannot be timely made, Dimplex may, in lieu of repair or replacement, choose to refund the purchase price for such product or part.
Replacement Parts Flicker Motor. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Heater Assembly (with Cutout) . . . . . . . . . . . . . . . . . . . Thermistor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Cord Set . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Flicker Rod . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Partially Reflective Panel. . . . . . . . . . . . . . . . . . . . . . . . Front Glass . . . . . . . . . . .