Owner’s Manual 6909410210 6909410110 6909680110 Model VF5452L VF2927L VFA2927 IMPORTANT SAFETY INFORMATION: Always read this manual first before attempting to install or use this Opti-V. For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.
Table of Contents Welcome & Congratulations . . . . . . . . . . . . . . . . . . . 3 IMPORTANT SAFETY INSTRUCTIONS. . . . . . . . . . 4 Opti-V Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Locating the Opti-V. . . . . . . . . . . . . . . . . . . . . . . . . . 6 Hardwire Installation. . . . . . . . . . . . . . . . . . . . . . . . . 6 Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Maintenance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Welcome & Congratulations Thank you and congratulations for purchasing an Opti-V from Dimplex. Please use our convenient online registration page to record your model and serial numbers for future reference at www.dimplex.com/register Model Number North America Limited DIMPLEX NORTH AMERICA 1367 INDUSTRIAL ROAD CAMBRIDGE, ON, N1R 7G8 CANADA MODEL MODELE MODELO CAT.# No. de Cat. 6909410100 MADE IN IRELAND FAIT EN IRLANDE HECHO EN IRLANDA VF2927L 100-240V ~, 50/60HZ, 35W SERIAL No.
IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. The appliance shall not be exposed to dripping or splashing and that no objects filled with liquid, such as vases, shall be placed on the apparatus.
IMPORTANT SAFETY INSTRUCTIONS only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons. 18. When transporting or storing the unit and cord, keep in a dry place, free from excessive vibration and store so as to avoid damage. 19. Do not install the remote control battery backwards; charge; put in excessive heat such as fire, sunshine or the like; or mix with used or other battery types - may explode or leak causing injury. 20.
Opti-V Installation WARNING: ANY INSTALLATION AND SERVICE WORK CAN ONLY BE PERFORMED BY QUALIFIED AND AUTHORIZED PERSONNEL. ALL INSTALLATIONS MUST COMPLY WITH ALL LOCAL CODES AND BYLAWS, AND INSPECTED AND APPROVED FOR OPERATION BY LOCAL GOVERNING AUTHORITY PRIOR TO USE. WARNING: Construction and electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electric shock and injury to persons.
Opti-V Installation recommended dimensions located in Figure 1. ! NOTE: Dimensions provided are minimum clearances and will vary depending on type of support framing and finishing options. ! NOTE: Framing should be constructed to support: VF2927L / VFA2927 - 63 lbs (29 kg) VF5452L - 116 lbs (52 kg) 2. Allow up to 4 ft. (121.9 cm) of service cable for connecting a power supply wire to the cable clamp on the Opti-V when installing before finishing wall.
Opti-V Installation Do not use cable with aluminum conductors. ! NOTE: It is recommended that all drywall installation and finishing be completed after unit is fully installed. 3. In the upper left hand corner of the unit, loosen the two securing screws and remove the electrical cover panel. (Figure 2) 4. Install a ⅜ in. (10 mm) or ½ in. (13 mm) cable connector, not included, suitable for mounting in a ⅞ in. (22 mm) hole, to the cable plate and feed the supply cable through the connector and secure. 5.
Opti-V Installation ! NOTE: Cap any additional wires from the power supply not used in the installation. 9. Ensure that the green grounding wire is securely attached to the back plate. CAUTION: Ensure the wire connectors are securely tightened, so no bare wires (live or neutral) are exposed. 10. Ensure the grounding wire of the supply cable is securely attached to the grounding screw.
Operation Figure 2 A B C D E F IR Remote Sensor WARNING: This Opti-V must be properly installed before it is used. The power switch (Figure 2A) must first be switched "I" to operate the appliance. An ‘Opti-V’ logo will appear on the screen for about 3 seconds before the flame picture starts . ! NOTE: The user may notice a blank screen for approximately 5 seconds, every 30 minutes. This is normal and should not be a cause for concern.
Operation button brightens the screen. ! NOTE: On the VF5452L there are brightness controls for each LED screen. The brightness controls for the right screen are located in the center of the unit. Figure 3 Volume Controls Battery Cover Remote Control Operation The remote control may be operated once the appliance is switched to the ON "I" position (Figure 2A). Aim the remote control at the IR remote sensor located on the left of the display (Figure 2).
Maintenance WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons. Glass Cleaning Servicing Except for installation and cleaning described in this manual, an authorized service representative should perform any other servicing. The glass is cleaned in the factory during the assembly operation. During shipment, installation, handling, etc.
Warranty Two Year Limited Warranty Products to which this limited warranty applies This limited warranty applies to the following models of your newly purchased Dimplex Opti-V: VF5452L, VF2927L and VFA2927 and to newly purchased Dimplex surrounds (mantels) and trims. This limited warranty applies only to purchases made in any province of Canada except for Yukon Territory, Nunavut, or Northwest Territories or in any of the 50 States of the USA (and the District of Columbia) except for Hawaii and Alaska.
Warranty • • • 14 repair or replace such defective product or part without charge. If Dimplex is unable to repair or replace such product or part, or if repair or replacement is not commercially practicable or cannot be timely made, Dimplex may, in lieu of repair or replacement, choose to refund the purchase price for such product or part. Limited warranty service will be performed solely by dealers or service agents of Dimplex authorized to provide limited warranty services.
Technical Support Technical and troubleshooting support, as well as a list of replacement parts can be found on www.dimplex.com/customer_support.
