SDS

TMMQ/GPTD-PS/A00
Guangzhou Tianqiu Enterprise Co., Ltd
We reserve all rights for the change of product specification and any information without any prior notice. Page 8 of 10
7．Caution for use
1) Since the battery is not designed to be charged, there are risks of electrolyte
leakage or causing damage to the device if the battery is charged.
2) The battery shall be installed with its “+” and “-” polarity in correct position,
otherwise may cause the battery to be charged or over-discharged.
3) Short-circuiting, heating, disposing of in fire and disassembling the battery are
prohibited.
4) Battery cannot be forced discharge, which lead to excess internal gas generation
and, may result in bulging, leakage and explosion.
5) New and used batteries cannot be mix used at the same time, when replaced
batteries, it is recommend to replace all and with the same brand type.
6) Exhausted batteries should be removed from compartment to prevent
over-discharge, which cause leakage and damage to the device.
7) Direct soldering is not allowed, which will damage the battery.
8) Keep the battery out of the reach of children to prevent swallow, in case of
accident should contact physician at once
9) The battery should not be dismantled and deformed.
Caution:
If the product leaked, the electrolyte get into the eyes, do not rub, wash eyes with
clean water, please immediately go to the hospital for treatment when necessary,
otherwise the eyes will be damaged.
If the product emits an odor, fever, discoloration, deformation or any abnormal
phenomena appeared in the process of use, storage, please remove the product
immediately from the device.