User manual

176 Bio-inert Quaternary Pump User Manual

12 Hardware Information

Setting the 8-bit Configuration Switch (without On-board) LAN

The 8-bit configuration switch is located at the rear of the module.

Modules that do not have their own LAN interface (e.g. the TCC) can be

controlled through the LAN interface of another module and a CAN

connection to that module.

Figure 20 Configuration switch (settings depend on configured mode)

All modules without on-board LAN:

• default should be ALL DIPS DOWN (= best settings)

• Bootp mode for LAN and

• 19200 baud, 8 data bit / 1 stop bit with no parity for RS-232

• DIP 1 DOWN and DIP 2 UP allows special RS-232 settings

• for boot/test modes DIPS 1+2 must be UP plus required mode

Switch settings provide configuration parameters for serial communication

protocol and instrument specific initialization procedures.

NOTE

For normal operation use the default (best) settings.

NOTE

With the introduction of the Agilent 1260 Infinity, all GPIB interfaces have been removed.

The preferred communication is LAN.