User manual

26 1260 Nanoflow Pump User Manual

1 Introduction to the 1260 Infinity Nanoflow Pump

Setting the 8-bit Configuration Switch (On-Board LAN)

The 8-bit configuration switch is located at the rear of the module. Switch

settings provide configuration parameters for LAN, serial communication

protocol and instrument specific initialization procedures.

All modules with on-board LAN, e.g. G1315/65C/D, G1314D/E/F, G4212A/B,

G4220A:

• Default is ALL switches DOWN (best settings) - Bootp mode for LAN.

• For specific LAN modes switches 3-8 must be set as required.

• For boot/test modes switches 1+2 must be UP plus required mode.

Figure 6 Location of Configuration Switch (example shows a G4212A DAD)

NOTE

To perform any LAN configuration, SW1 and SW2 must be set to OFF. For details on the

LAN settings/configuration refer to chapter LAN Configuration.