User manual

1260 Nanoflow Pump User Manual 49

Installing the Module

Installing the Pump

For other cables see text below and “Cable Overview” on page 172.

Parts required # p/n Description

1Pump

1 Data System

1 G4208A Instant Pilot

1 Power cord

Preparations • Locate bench space.

• Provide power connections.

• Unpack the module.

WARNING

Module is partially energized when switched off, as long as the power cord is

plugged in.

Repair work at the module can lead to personal injuries, e.g. shock hazard, when the

cover is opened and the module is connected to power.

➔ Make sure that it is always possible to access the power plug.

➔ Remove the power cable from the instrument before opening the cover.

➔ Do not connect the power cable to the Instrument while the covers are removed.

CAUTION

"Defective on arrival" problems

If there are signs of damage, please do not attempt to install the module. Inspection by

Agilent is required to evaluate if the instrument is in good condition or damaged.

➔ Notify your Agilent sales and service office about the damage.

➔ An Agilent service representative will inspect the instrument at your site and

initiate appropriate actions.