User manual

1260 Nanoflow Pump User Manual 51
Installing the Module
3
Installing the Pump
5 Connect the required interface cables to the rear of the pump, see
“Connecting Modules” on page 52.
Figure 13 Rear View of the Module
6 Connect the capillary, solvent tubes and waste line (see “Flow
Connections” on page 54).
7 Press the power switch to turn on the module.
8 Purge the pump (see “Priming Your System With the Pump” on page 59).
HZXjg^inAZkZg
8dc[^\jgVi^dchl^iX]
EdlZgEaj\
GH'('
GZbdiZ
6cVad\djieji
Hadi[dg^ciZg[VXZWdVgY
86C"7jh
NOTE
The power switch stays pressed in and a green indicator lamp in the power switch is on
when the module is turned on. When the line power switch stands out and the green light
is off, the module is turned off.
NOTE
The pump shipps with default configuration settings. To change these settings, see
“Setting the 8-bit Configuration Switch (without On-Board LAN)” on page 28.