Instructions / Assembly

9
e universal joint should be greased with chassis lube every week.
Grease the sliding drive shaft members with moly grease at the
beginning of each season of use. All post hole diggers are equipped
with quick release universal joints on the PTO end for a 1-3/8 in.
splined shaft.
Step 7: Attach the tractor end of driveline.
Attach the tractor end of the driveline to the tractor PTO shaft.
Push the spring loaded pin in the splined yoke and slip it onto the
splined PTO shaft of the tractor. Release the pin and push until it
locks securely.
Note: it may be necessary to obtain a 1-1/8 in. to 1-3/8 in. sleeve
spline adapter if the tractor has a 1-1/8 in. spline shaft.
Step 8: Check tightness of all bolts and nuts.
Stabilizers should be kept tight to avoid side sway of the post hole
digger.
See Figure A for reference in assembling the post hole digger and
attachment to the tractor.
Note: e boom angle can be adjusted on the tractor for proper
hole digging and ground clearance by moving the A frame to a
different mounting hole.
Note: If the 7/8 in. diameter pull pins are too small for the holes in
the lift arms, bushings should be used to obtain the correct fit for
operation.
Assembly Instructions