User`s guide

Page 2
Introduction
The DISH Pro Plus Twin LNBF features DISH Pro Plus Technology and provides reception from the 110
and 119 orbital locations. The device includes two receiver outputs and one input from an additional DISH
Pro Single, DISH Pro Dual, or a DISH Network bandstacked FSS LNBF supporting a third orbital
location.
This LNBF supports connection of up to two satellite receivers in any of the following combinations:
• Single-cable connection to DISH Pro Plus (dual-tuner) receivers, when each input is used with a DISH
Pro Plus Separator.
• Single-cable connection to DISH Pro receivers.
• Single-cable connection to one Legacy (no DISH Pro or DISH Pro Plus label) receiver, without a DISH
Pro Adapter. However, an additional satellite receiver must also be installed as follows:
- For 110W/119W reception only, a second operating satellite receiver must be connected to provide
power to the LNBF.
- For 110W/119W reception plus satellite reception from an additional compatible LNBF, a DISH Pro
or DISH Pro Plus receiver must also be installed to provide power to the LNBF.
Figure 1 shows the three ports provided on the DISH Pro Plus Twin LNBF. The ports marked
1 and 2 are
used to connect two satellite receivers. The port marked
LNB IN is used to connect to a DISH Pro Single,
DISH Pro Dual, or a DISH Network bandstacked FSS LNBF.
Figure 1. DISH Pro Plus Twin LNBF
This guide contains instructions for professional installation of the DISH Pro Plus Twin LNBF directly to
satellite receivers and to compatible DISH Pro Plus switches.