User`s guide

Page 6
Figure 4. DISH Pro Plus Installation Summary
• The summary screen below is similar to what should be shown for a Legacy
receiver connected to the DISH Pro Plus Twin LNBF. Make sure the summary
screen shows reception from both 110W and 119W satellites on all available
satellite tuners. If not, consult your receiver user's guide to re-peak your DISH
500 as needed. Note that the DP Plus Twin will be identified as SW64. This is OK
and does not indicate a problem.
Figure 5. Legacy Installation Summary
Select OK or Done to exit the Installation Summary screen. The Point Dish/Signal screen
should be displayed. Make sure the signal strength bar is green and locked for the 119W and
110W satellites.
Note: If the signal strength bar is not green and locked, toggle the transponder number up one
and then back down one.
Exit the
Point Dish screen and follow your receiver user's guide instructions for taking a
receiver software upgrade. If exiting the
Point Dish screen does not start the upgrade process
as described in the receiver user's guide, then turn off the receiver for at least 20 minutes to
allow the receiver to take a software upgrade.
Run
Check Switch again and re-confirm reception for 119W/110W satellites.