Owner's Manual

DJI RSC 2
User Manual
© 2020 DJI OSMO All Rights Reserved.
13
To avoid re, serious injury, and property damage, observe the following safety guidelines
when using, charging, or storing the grip.
Grip Use
1. DO NOT allow the grip to come into contact with any kind of liquid. DO NOT leave the
grip out in the rain or near a source of moisture. DO NOT drop the grip into water. If the
inside of the battery comes into contact with water, chemical decomposition may occur,
potentially resulting in the battery catching on re, and may even lead to an explosion.
2. If the grip falls into water by accident, put it in a safe and open area immediately.
Maintain a safe distance from the grip until it is completely dry. DO NOT use the grip
again, and dispose of the grip properly as described in the Grip Disposal section.
3. Put out any re using water, sand, re blanket, or a dry powder re extinguisher.
4. DO NOT use non-DJI batteries. DJI takes no responsibility for any damage caused by
non-DJI batteries.
5. DO NOT use or charge a swollen, leaky, or damaged grip. If the grip is abnormal,
contact DJI or a DJI authorized dealer for further assistance.
6. The grip should be used in temperatures from -20° to 45° C (-4° to 113° F). Use of the
grip in environments above 50° C (122° F) can lead to a re or explosion. Use of grip
below -10° C (14° F) can lead to permanent damage.
7. DO NOT use the grip in strong electrostatic or electromagnetic environments.
Otherwise, the battery control board may malfunction.
8. DO NOT disassemble or pierce the grip in any way or the battery may leak, ignite, or
explode.
9. DO NOT drop or strike batteries. DO NOT place heavy objects on the grip or charger.
10. Electrolytes in the battery are highly corrosive. If any electrolytes make contact with
your skin or eyes, immediately wash the affected area with fresh running water for at
least 15 minutes, and then see a doctor immediately.
11. DO NOT use the grip if dropped.
12. DO NOT heat batteries. DO NOT put the grip in a microwave oven or in a pressurized
container.
13. DO NOT manually short-circuit the grip.
14. Clean grip terminals with a clean, dry cloth.
Grip Charging
1. DO NOT leave the grip unattended during charging. DO NOT charge the grip near
ammable materials or on ammable surfaces such as carpet or wood.
2. Charging the grip outside of the temperature range of 5° to 40° C (41° to 104° F) may
lead to leakage, overheating, or battery damage. The ideal charging temperature is
22° to 28° C (72° to 82° F).