User manual

22
©
2018 DJI All Rights Reserved.
MATRICE 200 User Manual
Use the Failsafe RTH for example:
..
1. Record Home Point 2. Remote Control Signal Lost
5. Landing (After User Conrmation)
3. Signal Lost for Extended Time
4. RTH (Adjustable Altitude)
Height over HP<=Failsafe Altitude
Height over HP>Failsafe Altitude
Elevate to Failsafe Altitude
Failsafe Altitude
Hovering at 0.7 meters above the Home Point
Aircraft cannot return to the Home Point when GPS signal is weak ( [ ] Less than 4
bars is considered a weak GPS signal) or unavailable.
User cannot control the aircraft while the aircraft is ascending to 65 feet (20 meters) from
the current altitude. However, users can press the RTH button once to exit ascending and
regain control.
The aircraft will automatically descend and land if RTH is triggered when the aircraft ies
within a 65 feet (20 meters) radius of the Home Point. The aircraft will stop ascending and
will return to the Home Point if the aircraft reaches 65 feet (20 meters) in altitude or beyond
during Failsafe.
The aircraft cannot avoid obstacles during Failsafe RTH if the Forward Vision System is
disabled. It is important to set a suitable RTH Altitude before each ight. Launch DJI GO 4,
enter camera and tap
to set Failsafe Altitude.
Failsafe Safety Notices
20 m
20 m
RTH Altitude
The aircraft cannot avoid obstacles during Failsafe RTH when the
Forward Vision System is disabled. Therefore, it is important to set a
suitable Failsafe altitude before each ight. Launch the DJI GO 4 app,
enter Camera and tap
to set the Failsafe Altitude.
20 m
20 m
RTH Altitude
If the aircraft is ying under 65 feet (20 meters) and Failsafe (including
Smart RTH, Lower Battery RTH) is triggered, the aircraft will first
automatically ascend to 65 feet (20 meters) from the current altitude. You
can only cancel the ascending by exiting the Failsafe.
20 m
20 m
H
RTH Altitude
The aircraft automatically descends and lands if RTH is triggered when
the aircraft ies within a 65 foot (20 meter) radius of the Home Point. The
aircraft will stop ascending and immediately return to the Home Point if
you move the left stick when the aircraft is ying at an altitude of 65 feet (20
meters) or higher and Failsafe is triggered.
20 m
20 m
RTH Altitude
The aircraft cannot return to the Home Point when GPS signal is weak
( [
] displaying less than four bars) or is unavailable.