User manual
Table Of Contents
38
©
2018 DJI All Rights Reserved.
Remote Controller
Remote Controller Prole
The Matrice 200 remote controller is a multi-function wireless communication device that integrates
a dual frequency video downlink system and the aircraft remote control system. 2.4 GHz frequency
is suitable for long transmission distances in open areas while 5.8 GHz frequency* is appropriate
for urban areas, being resistant to increased interference (5.8 GHz transmission is not available in
some regions due to local regulations).The remote controller features many camera control functions,
including photo/ video capture and gimbal control. The battery level is displayed via LED indicators
on the front panel of the remote controller. When in Dual Remote Controller mode, each of the two
remote controllers will control aircraft and camera separately, and up to 328 feet (100 meters) apart.
Compliance Standards: The remote controller is compliant with local laws and regulations.
Stick Mode: Controls can be set to Mode 1, Mode 2, or to a custom mode.
Mode 1: The right stick serves as the throttle.
Mode 2: The left stick serves as the throttle.
Do not operate more than three aircraft within the same area (roughly the size of a soccer
eld) to prevent transmission interference.
* To comply with local regulations, the operation frequency of 5.8GHz is not available in some countries.
Remote Controller Operations
Turning the Remote Controller On and Off
The Matrice 200 remote controller is powered by a 2S rechargeable battery with a capacity of 6000
mAh. The battery level is indicated by Battery Level LEDs on the front panel.
1. When powered off, press the Power button once and the Battery Level LEDs will display the current
battery level.
2. Next, press and hold the Power button to power on the remote controller.
3. The Remote Controller will beep when it powers on. The Status LED will blink green and the
secondary remote controller will blink solid purple rapidly, indicating that the remote controller is
linking to the aircraft. The Status LED will show a solid green light when linking is complete.
4. Repeat step 2 to power off the remote controller after you nish using it.