User manual

Table Of Contents

MATRICE 200

User Manual

GEO Unlocking

Due to differing laws and regulations between countries and regions, and differing ight restrictions

between GEO Zones, DJI provides users with two methods for unlocking GEO Zones: Self-Unlocking

and Custom Unlocking.

Self-Unlocking is used for Authorization Zones, where the user is required to submit an unlock

request by authenticating their phone number for a registered DJI account. This feature is only

available in certain countries. Users can choose whether to submit their unlock request via the web-

site at https://www.dji.com/ysafe (Scheduled Self-Unlocking), or through the DJI GO 4 app (Live

Self-Unlocking).

Custom Unlocking is based on special requirements for individual users. It sets a special ight

area that users can unlock by providing ight permission les according to their specic GEO

Zone and other requirements. It is available in all countries and can be applied for on the website:

https://www.dji.com/ysafe.

For more information about unlocking, please visit https://www.dji.com/ysafe or contact ysafe@

dji.com.

Preight Checklist

1. Remote controller, Intelligent Flight Battery, and mobile device are fully charged.

2. Propellers are mounted correctly and rmly.

3. Micro SD card has been inserted, if necessary.

4. Gimbal is functioning normally.

5. Motors can start and are functioning normally.

6. The DJI GO 4 app is successfully connected to the aircraft.

7. Ensure that the sensors for the Obstacle Sensing System are clean.

Calibrating the Compass

Only calibrate the compass when the DJI GO 4 app or the status indicator prompts you to do so.

Observe the following rules when calibrating your compass:

DO NOT calibrate your compass where there is a chance of strong magnetic interference,

such as near magnets, parking structures, or steel reinforcements underground.

DO NOT carry ferromagnetic materials with you during calibration such as cellular phones.

The DJI GO 4 app will notify you if the compass is affected by strong interference after

calibration is complete. Follow the prompts to resolve the compass issue.

Calibration Procedures

Choose an open area to carry out the following procedures.

1. Tap the Aircraft Status Bar in the app and select Calibrate, then follow the on-screen instructions.

2. Hold the aircraft horizontally and rotate it 360 degrees. The Aircraft Status Indicators will go solid

green.