Manualshelf

User manual

ManualsBrandsDJI ManualsDronesMatrice 200
61626364656667686970
Table Of Contents
©
2018 DJI All Rights Reserved.
65
MATRICE 200
User Manual
OR
Stopping the Motors
There are two ways to stop the motors:
1. When Matrice 200 has landed, push the left stick down , then conduct the same CSC that was
used to start the motors, as shown above
. Motors will stop immediately. Release both sticks
once motors stop.
Auto Takeoff and Auto Landing
Auto Takeoff
Use auto takeoff only if the Aircraft Status Indicators are blinking green. Follow the steps below to
use the auto takeoff feature:
1. Launch the DJI GO 4 app and tap GO FLY to enter Camera View.
2. Complete all steps on the pre-ight checklist.
3. Tap“
”, and conrm that conditions are safe for ight. Slide the icon to conrm and takeoff.
4. Aircraft takes off and hovers at (1.2 meters) above ground.
Aircraft Status Indicator blinks rapidly when it is using the Vision System for stabilization.
The aircraft will automatically hover below 10 meters. It is recommended to wait until there
is sufcient GPS lock before using the Auto Takeoff feature.
Auto-Landing
Use auto-landing only if the Aircraft Status Indicator is blinking green. Follow the steps below to use
the auto-landing feature:
1. Tap
, to ensure that landing conditions are ideal. Slide to conrm.
2. Abort landing process immediately by tapping
on the screen.
3. a. When Landing Protection determines that the ground is suitable for landing, the Matrice 200
will land gently.
b. If Landing Protection determines that the ground is not suitable for landing, the Matrice 200
will hover and wait for pilot conrmation.
c. If Landing Protection is not operational, the DJI GO 4 app will display a landing prompt when
the Matrice 200 descends below 0.7 meters. Pull down on the throttle or use the auto landing
slider to land.
4. The aircraft will land and turn off automatically.
Starting/Stopping the Motors
Starting Motors
The Combination Stick Command (CSC) is used to start the motors. Push both sticks to the bottom
inner or outer corners to start the motors. Once the motors start spinning, release both sticks simul-
taneously.