User manual

66
©
2018 DJI All Rights Reserved.
MATRICE 200 User Manual
OR
Method 1 Method 2
Stop the Motor Mid-ight
Pull the left stick to the bottom right inside corner and press the RTH button at the same time.
Only stop
the motors mid-f light in emergency situations when doing so reduces the risk of damage or injury.
2. When the aircraft has landed, push and hold the left stick down. The motors will stop after three
seconds.
Flight Test
Takeoff/Landing Procedures
1. Place the aircraft in an open, at area with the battery level indicators facing towards you.
2. Turn on the remote controller and your mobile device, then turn on the Intelligent Flight Battery.
3. Launch DJI GO 4 and enter the Camera View.
4. Wait until the Aircraft Indicators blink green. This means the Home Point has been recorded and
it is now safe to y. If they ash yellow, the Home Point has not been recorded.
5. Turn on the motors using CSC and push the left stick up slowly or use Auto Takeoff to take off.
6. Shoot photos and videos using the DJI GO 4 app.
7. To land, hover over a level surface and gently pull down on the left stick to descend.
8. After landing, execute the CSC command or hold the left stick at its lowest position until the mo-
tors stop.
9. Turn off the Intelligent Flight Battery rst, then the remote controller.
When the Aircraft Status Indicators blink yellow rapidly during ight, the aircraft has entered Failsafe
mode.
A low battery level warning is indicated by the Aircraft Status Indicators blinking red slowly
or rapidly during ight.
Watch our video tutorials for more ight information.
Please check that CSC is activated inside DJI GO 4 app, then the user can stop the
aircraft mid-air.