Use and Care Manual

EVST9022 man. v.201130 | 11
ENGLISH
INSTALLATION STEPS
•Secure the breaker to the fender or firewall with the use of
screws or zip ties in a place where it will not come into contact
with negative terminal.
•Attach the negative (black) lead to the negative “-“ battery
terminal.
•Route the wires from the battery in the best possible way to
the front of the vehicle, avoiding areas that can become hot or
cause friction when the vehicle is in use. Zip tie the
wires to the vehicle’s structure to that they do not move or
shift when in operation. Confirm the breaker is in the closed
position, and then close the hood slowly to make sure yet
again that the wires are clear from pinch points.
STEP 21:Mount plow to vehicle and fasten using safety clips.
STEP 22:Install remote.
•Connect power.
•Connect handheld controller.
STEP 23:Once installed, use remote to raise and lower plow as well as tilt
left and right to ensure hydraulic lines are drained of any air. Once
all functions of the plow have been completed, fill the pump tank
back up to the fill line with second bottle of fluid provided.
IMPORTANT: Make sure to leave slack in both cables spanning from the vehicle to snowplow control box. This allows the
cables to free float when the snow plow is in use. If they are tight they may become undone or damaged.