Use and Care Manual

EVST9022 man. v.201130 | 9
ENGLISH
STEP 7:Open second box and remove contents. Leave complete main
frame structure in the box to allow for easier installation.
STEP 8:Remove hardware from pivot arm brackets and with assistance,
slide the main frame into the plow blade so that the pivot arm
brackets align with the predrilled holes of the plow blade.
STEP 9:Hand tighten pivot arm to plow blade.
STEP 10:Remove tie straps from both red hydraulic cylinders and loosen
fittings to allow enough air out to allow the cylinder to compress.
STEP 11:Get the castor assembly and remove the large bolt, spring, washer
and nut allowing the bracket that fastens to the frame to be free of
the castor stem.
STEP 12:Align castor bracket with predrilled holes on the blade assembly
and hand tighten using bolt, spring, washer, and nut.
STEP 13:Insert end of cylinder into middle of castor bracket and insert bolt
from top of bracket through the cylinder end and through the
bottom of the castor bracket then fasten all hardware/hose fittings.
STEP 14:Drop castors down for more stability during rest of assembly.
STEP 15:Hook large springs onto the top of the blade assembly.
STEP 16:Hook eye bolt onto the bottom of the spring and put threaded
end through predrilled tab on main frame. There should be a nut
on the threading of the eye bolt above the tab as well as under the
tab. Tighten nut on the end of the eyebolt until there is tension on
the spring.
PLOW ASSEMBLY