Service and Repairs

93
Reassembly
17 690 01 Rev. L KohlerEngines.com
CH395
Governor Details
A
B
C
F
D
E
G
A Thrust Washer B Governor Gear
C Pin Rim D Washer
E Hitch Pin F Thrust Washer
G Governor Cross
NOTE: Governor gear shaft is pressed into closure plate
and should not be removed.
1. Assemble governor gear pin into governor gear so
pin rim is held in place by weight retainers.
2. Place thrust washer on governor gear shaft in
closure plate. Push governor gear onto shaft.
3. Install one thrust washer onto governor cross shaft
and slide shaft up through inside of crankcase.
4. Install second fl at washer onto shaft. Position shaft
so fl at index end of shaft faces left (9 o'clock
position) and insert hitch pin from PTO side.
CH440
Governor Details
B
A
C
H
G
D
E
F
K
I
J
L
A
Closure Plate
Sealing Surface
B
Governor Gear
Shaft
C Height D Pin Rim
E Ring F Weights
G Governor Gear H Thrust Washer
I Washer J Hitch Pin
K Thrust Washer L Governor Cross
1. If shaft was removed in disassembly, use an arbor
press to install new shaft to a height of 16.025 mm
(0.6309 in.) from closure plate sealing surface.
2. Place washer onto shaft, then place governor gear
onto shaft.
3. Press a new ring onto shaft about 1/8 in.