Operation Manual

- 21 -
Getting started
Place the MusicFly Select into the 12V cigarette lighter socket
power. Adjust the device, that it can be operated comfortably.
The display appears immediately. The equipment is ready for
use. The MusicFly Select checks whether a device is attached
to the USB port or a SD card is in the card slot and starts to
playback the music.
Switch on from standby mode
Press and hold the POWER button for 2 seconds
to turn the unit on. The previous display settings
appear. The MusicFly Select checks whether a
device is attached to the USB port or a SD card is in
the card slot and starts to playback the music.
Switch off
The unit switches off automatically after 60 minutes when no
music is played . Alternatively the unit can be switched off with
the POWER button
Standby Mode
If no audio device is connected to the USB port, SD card slot
or audio in or the device is in PAUSE mode the device turns off
after 1 Minute. A noise is heard in the radio. If the audio device
is connected to the MusicFly Select in the next 60 Minutes, the
device turns itself on automatically, otherwise turn the device
on with the POWER button.
If the menu for the settings is active, then a LED
below the MENU/REPEAT button appears.
Setup fequency manually
Press the MENU/REPEAT-button.
Adjust the frequency with the / -buttons.
Press the MENU/REPEAT-button once again.
Setup fequency automatically
Press the SEARCH-button.
The display shows Ato shortly and starts scan-
ning a new frequency.
Getting started
MFlysSlect DEFN.indd 21MFlysSlect DEFN.indd 21 23.10.2008 16:33:0323.10.2008 16:33:03