Manual
- 4 -
* The iQ No Bark Collar has a preset delay of 15 seconds in-between
corrections. Once the unit activates, it WILL NOT activate again until
15 seconds has gone by. (The unit will reset to the warning
non-stimulating vibration after 17 seconds of a correction if the dog
does not bark.)
- Turn the On/Off and Intensity Dial to (T), for the test mode. The LED
indicator will flash once, and after 2 seconds it will continue flashing
every 2 seconds.
- Activate the collar by making sounds directly into the mic. The unit
should now vibrate twice. After waiting 15 seconds, repeat the test once
more to verify that it is fully functional.
1. With the On/Off
Intensity Dial going in
first, insert the body of
the iQ No Bark Collar
into the collar strap.
3. Be sure that the collar
strap is wrapped fully
around the body of the
iQ No Bark Collar.
2. Pull the collar strap
from the opposite side
of the On/Off Intensity
Dial over the rest of
the body.
Hold strap here Hold strap here
Pull the strap around the body
of the iQ No Bark Collar
in the direction shown.
ATTACHING THE COLLAR STRAP
TESTING THE IQ NO BARK COLLAR
- When the iQ No Bark collar is first activated by the dog’s bark, the
unit will give a warning non-stimulating vibration. If the dog
continues to bark, the unit will give a non-stimulating vibration
followed by a correction at the level it is set on.
* When on the test mode, the sensor may be sensitive enough that it may
activate easily by a quiet sound or tap.
* For video instructions on how to attach the collar strap, please visit
ZZZLTSHWFROODUFRP