® Hidden Fence Systems Performance Series TM Instructions For Use PT3 Transmitter and R7 and R8 Receivers
Important Safeguards DOGWATCH STRONGLY RECOMMENDS THAT YOU REMOVE THE COLLAR AT NIGHT WHILE YOUR DOG IS INSIDE • Please read all the literature included with your DogWatch® Hidden Fence System before turning the system on or beginning training. • • Do not attempt to shortcut the complete training of your dog. • In the event your system requires servicing, please contact your local Authorized DogWatch Dealer. Attempting to service the system yourself may invalidate the warranty.
Product Description Performance™ Series Transmitter The transmitter sends a coded digital FM radio signal through the boundary wire. This signal can be adjusted, allowing you to control the “hidden fence” around your property. It operates on a standard 110 volt outlet. 7 Training Mode 6 4 Pulse Rate Range 1 Power On/Off 8 10 Loop Plug Model Switch Leave in UP position at all times Power Pak™ Power Supply 9 Ground Wire 3 2 Inset POWER Light: Steady Red light when power is on.
Performance™ Series Transmitter Features 1. Power On/Off: This switch gives you easy access to turn the transmitter on or off. The red Power indicator light on the front panel lets you know that it is operating. 2. Power Supply: The transmitter is powered through a power supply that is plugged into a properly grounded 110 volt outlet. The adapter is plugged into the transmitter jack labeled “PWR.” 3. Ground Wire: The green ground wire is plugged into the transmitter at the location labeled “GND.
9. PowerPak™: Optional battery back-up system keeps the transmitter operating in the event of a power failure. When transmitter is being powered by battery back-up, the red power light will remain off. PowerPak plugs into the transmitter at “P-PAK”. 10. Model Switch: This switch sets your transmitter to work with your specific receiver(s). Your DogWatch Dealer will set the switch in the “up” position. The Transmitter must be turned off when setting or changing this switch.
R7 and R8 Receiver Features Contact Posts Adjustable Nylon Collar Metal Lock Washer CollarBone Battery Cap Test Light Magnet Hold Magnet Between Two Lines 3.6 Volt Battery Adjustable Collar: Both the R7 and R8 receivers come fitted to an adjustable nylon collar. The collar should be positioned above the dog’s regular collar. The collar should be adjusted to insure that the contact posts touch the skin on the dog’s neck.
Test Light: The test light allows you to test the receiver. Hold the test light over the contact posts as shown in Figure 3 and carry the receiver into the signal field a few feet from the ground. When the receiver picks up the signal from the boundary wire, the audible warning will sound and the test light will come on when you enter the correction zone. Status Light: Both the R7 and R8 include a status light to help you with the operation of your receiver. Figure 3.
Setting The Transmitter: The Transmitter Rate switch adjusts to three settings: (1 – slow, 2 – medium, 3 – fast). When your dog gets a correction, he receives it in a series of pulses per second. Increasing the rate means that he will receive a greater number of pulses per second. Rate 1 is the slowest pulse rate per second; 3 is the fastest.
Receiver Levels and Transmitter Settings TRANSMITTER RATE SETTINGS RECEIVER TRAINING LEVELS Audible Only 1 Low 2 Medium AUTOMEMORY 3 Medium-High AUTOMEMORY 4 High AUTOMEMORY* 5* X-High 1 medium slow slow slow X-fast XX-fast 2 medium medium medium medium X-fast XX-fast 3 medium fast fast fast X-fast XX-fast *When the Receiver Training Level is set to audible, 4 or 5, it will override the transmitter “Rate” Setting and remain constant.
How The DogWatch System Works The boundary wire creates the perimeter for the DogWatch Hidden Fence System, and can enclose any area up to 200 acres. It is buried at least 3 - 4” beneath the surface of the yard or can lie on top of the ground (e.g.: in wooded or rocky areas). It can also be installed around gardens or swimming pools, or attached to an existing fence to prevent your dog from digging under or jumping over it.
Adjusting the Receiver Collar 1. The collar should be worn snugly on the dog’s neck. This is extremely important! 2. Place no more than one thumb width between the contact post and dog’s neck. 3. When checking snugness of collar, the dog’s neck should be facing down (sniffing position) as this is where the dog’s neck is the smallest. 4. If the collar is too tight, the receiver unit will stick out to the side when the dog shakes his head. 5.
Important Reminders: u Keep the transmitter and receiver collar out of reach of children. u Never attempt to service the receiver or transmitter yourself. u Be sure your transmitter and surge protector are properly grounded. u Fit the collar snugly around your dog’s neck. u Make sure that battery is fresh and is inserted correctly. u Train your dog as outlined in the DogWatch Owner’s Guide. u Never adjust the transmitter while your dog is wearing the receiver collar.
Replacement Batteries and Collars R7 Batteries must be replaced every 6 months. Replacement battery: 3.0 Volt 1/3 N Lithium. R8 Batteries must be replaced every 24 months. Replacement battery: 3.6 Volt Lithium. For replacement batteries and nylon collars, contact your Authorized DogWatch Dealer. Visit our web site at www.dogwatch.com - click on “Locate a Dealer” or contact Customer Service at: 800-793-3436x extension 623.
Warranty Registration Your Warranty Registration card must be complete for your warranty to be activated. Fill out the enclosed Warranty Registration card and mail back to DogWatch within seven (7) days. For your convenience, you can also complete your warranty registration online at www.dogwatch.com. Manufacturer’s Warranty 1. WARRANTY: DogWatch Inc.
Notes 14
® ® HIDDEN FENCE SYSTEMS 10 Michigan Drive • Natick • MA • 01760 800-793-3436 • www.dogwatch.com DogWatch, the DogWatch logo, and SafeLink are registered trademarks of DogWatch Inc. Performance Series, PowerPak, AutoMemory, Pet Friendly, and Surrounding Pets With Freedom Since 1990 are trademarks of DogWatch Inc. DogWatch products are protected under U.S. Patent Nos.: 5,353,744; 6,079,367; 6,467,435; 6,360,698; 6,575,120; 5,465,687 and D,491,4815.
