Specifications

Setting The Transmitter: The Transmitter Rate switch adjusts to three settings:
(1 – slow, 2 – medium, 3 – fast). When your dog gets a correction, he receives it in a series
of pulses per second. Increasing the rate means that he will receive a greater number of
pulses per second. Rate 1 is the slowest pulse rate per second; 3 is the fastest.
Setting The Receiver: Both R7 and R8 Receivers provide six training levels that allow
you to customize the training setting to your dog’s individual needs:
Audible Only, Level
1(low), Level 2 (medium), Level 3 (medium high), Level 4 (high), and Level 5 (extra-
high). When the receiver is first turned on (from the manufacturer) it will automatically
be set to Training Level 2 (Medium).
Changing the R7 and R8 Receiver Settings
Your Dogwatch Dealer will start the training on the appropriate level according to your
dog’s personality and traits. If you need to change the training level on the receiver,
hold your test light magnet to the two raised lines on the side of the receiver
(Figures
4 and 5
.) Hold the magnet steady and you will hear a series of beeps that indicate the
current (set) training level. The Training Level will continue to advance as long as the
magnet is held in position. For example, Level One is one beep, Level 2 is two beeps,
etc. The beeps (or Receiver Tones) represent the Training Level the receiver is set at.
See Chart on Page 8.
When you reach the desired training level setting, pull the magnet away from the
receiver. The receiver is now set.
Note: Any time the magnet activates the receiver, it
will first tell you what level the receiver is set to and as long as the magnet is held in
place, it will advance the receiver to the next training level and continue to cycle
through the settings in the order shown in the chart on Page 8.
AUTOMEMORY™ Correction:
The R7 and R8 Receivers includes an AUTOMEMORY™ feature on training levels 2, 3 and
4. When the correction level is set to any of these three settings, and the dog challenges
the boundary, the AUTOMEMORY feature will enable as the dog leaves the audible zone
and returns to the Safety Zone. The receiver will then advance to the next highest
“Receiver Training Level”. The “rate” will remain in the existing “1, 2, 3 setting but will
jump to the next level per the chart on the page 8. If the dog challenges the boundary
again within 24 hours, he will receive that next highest correction level.
The receiver will
not advance to any higher level.
7
Figure 4: R7 Receiver Settings
Figure 5: R8 Receiver Settings