User`s guide

Chapter 1 19
Connections & Setup
Selecting a VCR Type
In order to use the One-Touch Record and Timer features, you need to tell the
satellite receiver which VCR brand you are using.
1. Tune the TV to its satellite receiver viewing channel (either 03, 04, or the
TV’s appropriate input channel depending on your connections).
2. Press MENU on the remote control to display the satellite receiver’s Main menu.
2. Highlight and select number 7, System Setup.
3. Highlight and select number 3, System Options.
4. Highlight and select number 2, Set VCR Type.
5. Highlight and select the name of your VCR manufacturer.
Note: If you do not see your VCR manufacturer’s name, select Other (at the
bottom of the list) and enter the appropriate code from the VCR Remote
Control code list on page 27.
6. Follow the on-screen instructions to ensure that you are using the correct
code (if you need more assistance while in a menu, press the remote
control’s INFO button for details).
Note: Some VCR brands may not be capable of being controlled by the
receiver.
Complete the Assisted Setup
If you installed your satellite dish antenna yourself, you may have already used
the Assisted Setup to find dish-pointing coordinates, acquire and fine-tune the
signal, and run a system test.
If you need to run the setup again, select System Setup from the Main menu,
then select Assisted Setup.
To check your dish-pointing coordinates or run the signal strength meter,
display the Main menu, then select System Setup, and finally Dish Pointing.