User`s guide

58 Chapter 4
Using On-Screen Menus
Output Channel
This feature allows you to change the channel to which the satellite receiver
broadcasts its signal. The default setting is channel 3.
Note: If you used A/V cables to connect your digital satellite receiver to your
TV, then you must use the TV’s video line input to see the satellite broadcast.
Remote Setup
This allows you to choose which remote control button will control the digital
satellite receiver. You can choose between SAT and AUX buttons. The default is
SAT.
Use the remote control’s arrow and OK buttons to make your choice.
RF Remote Setup
This feature allows you to configure the RF remote control’s privacy code. This
is the best way to avoid interference between your satellite receiver’s remote
control and other Thomson RF remote controls. This is helpful if you are using
two satellite receivers, each with RF remote controls.
Use the remote control’s arrow and OK buttons to make your choice. Follow
the on-screen instructions for details.
Picture Size
Selecting Picture Size allows you to select the type of TV connected to the
receiver. You can choose between Normal (4X3) or Cinema (16X9). The default
is Normal.
Dolby Digital
This menu feature allows the system’s audio output to use Dolby-Digital quality
sound. You must have the digital satellite system attached to a Dolby Digital-
enabled receiver or decoder via the DIGITAL AUDIO output jacks on back of
the satellite receiver in order for this feature to work.