Instruction manual

Suction head in the fuel tank

The felt lter (1) of the suction head is used to lter the fuel required by the –

carburetor.

A periodical visual inspection of the felt lter is to be conducted. –

For that purpose, open the tank cap, use a wire hook and pull out the suction

head through the tank opening.

Filters found to have hardened, been polluted or clogged up are to be

replaced.

Insufcient fuel supply can result in the admissible maximum speed being –

exceeded. It is therefore important to replace the felt lter at least quarterly to

ensure satisfactory fuel supply to the carburetor.

Cleaningofmuferexhaustport

Check of mufer exhaust port (2) regularly. –

If it is clogged by carbon deposits, carefully scratch the deposits out with a –

suitable tool.

Do not allow carbon to fall into engine ports.

Any maintenance or adjustment work that is not included and described in this manual is to be performed by Authorized Service Agent only.

Daily checkup and maintenance

To ensure a long service life and to avoid any damage to the equipment, the following servicing operations should be performed at regular

intervals.

Before operation, check the machine for loose screws or missing parts. Pay particular attention to the tightness of the cutter blade screws. –

Before operation, always check for clogging of the cooling air passage and the cylinder ns. Clean them if necessary. –

Perform the following work daily after use: –

Clean the Hedge Trimmer externally and inspect for damage.•

Clean the air lter. When working under extremely dusty conditions, clean the lter several times a day.•

Check the blades for damage and make sure they are rmly mounted.•

(1)

(2)