Manual

8
CoolFreeze
Safety Instructions
2.1 General safety
Caution – Danger of electrocution!
When using the device on boats: If the device is powered by the
mains, ensure that the power supply is protected with a ground
fault interrupter circuit.
Check that the voltage specification on the type plate corresponds to
that of the energy supply.
Only connect the device as follows:
With the cable supplied (Fig. 1 2, page 4) to the cigarette lighter
in the vehicle or to a 12/24 V plug socket in the vehicle
or with the enclosed connection cable (Fig. 1 3, page 4) to the
100-240 V AC mains (only CF-35, CF-40, CF-50, CF-60).
If the connection cable is damaged, it must be replaced to prevent
possible electrical hazards.
Do not pull the plug out of the cigarette lighter or the socket by the
cable.
Pull out the connection cable:
Before cleaning and maintenance
After use
Before changing a fuse
Disconnect the cooling device and other power consuming devices
from the battery before you connect the battery to a quick charging
device. Overvoltage can damage the electronics of the device.
Electronic devices are not toys!
Always keep and use the device out of the reach of children.
Do not operate the device if it is visibly damaged.
This device may only be repaired by qualified personnel. Inadequate
repairs can lead to considerable hazards.
Should your device need to be repaired, please contact WAECO
customer service.
Do not open the refrigerant circuit under any circumstances!
The cooler is not suitable for transporting caustic materials or
materials containing solvents.
Food may only be stored in its original packaging or in suitable
containers.
CF18-60_M_81003:PowerVac_PV-100 3/9/08 3:53 PM Page 8