Service manual

11
- Disconnecting electrical wires, removing defective lighting device.
- Reconnecting electrical wires in new casing. Prior to wiring, wires must be
threaded in the appropriate bore of the reflector holder. (Fig. 39)
- Placement of the socket in the casing so that its securing rib fits in the
groove of casing. Screws securing the wires must stand outwards from
lighting device. (Fig. 40)
- Insert control switch while holding socket in place with your finger. Screw in
bulb while constantly holding down the socket. (Fig. 41)
The bulb holds the socket elements in place, then the reflector mount can
be popped open. When snapping shut, the blocking tab should be slightly
pressed with a screwdriver. (Fig. 42, 43)
- After snapping shut, fitting should be tested.
- Replacing light shield. Make sure that the groove fits correctly on the light
shield.
While pushing aside the blocking tab of the reflector plate with a
screwdriver, the casing can be pushed in place. (Fig. 44)
Figure 40
Figure 39
Figure 41
Figure 42 Figure 43