Service manual

12
- Prior to installing the lighting device, the securing screws must be
reinserted into the lighting device so that the tips of the screws overhang
by 1-2 mm. These help positioning. (Fig. 45)
- Install lighting device, with attention to the placement of electrical wires.
- Tightening securing screws. Make sure it fits correctly. Then must be no
gap between the lighting device and the inner compartment.
2.3.2. Replacing bulb without dismounting the lighting device
- By pushing the reflector plate unhinge blocking tab on reflector from the
light shield. At the same time, push the light shield off of the casing with a
screwdriver. (Fig. 46)
- Unscrew defective bulb and replace with a new one; pay attention to
appropriate back-up power. Bulb needs to be tightened to an extent that
loose connection does not cause contact failure. (Fig. 47)
- Replacing the light shield. Make sure the groove fits correctly on the light
shield. (Fig. 48)
The light shield can be slid in place by slightly pressing the blocking tab
with a screwdriver.
Figure 44 Figure 45
Figure 46 Figure 47
Figure 48