Service manual

6
- Stand cabinet on its legs.
- Place door on bottom door mount.
- Place the replaced top door mount pin into top door mount bore of door,
then push door mount into left-hand-side opening of cabinet and secure
with 2 screws. (Fig. 10)
- Push door mount hole cover into upper right-hand-side opening, then
secure with a screw. (Fig. 11)
Make sure of unhindered opening and appropriate secure sealing of the door.
If needed, make corrections after loosening the screws that secure the door.
Re-fasten the screws.
- When only replacing the door, dismounting of the door mount hole cover
and door stop or the switching of the door mounts is not necessary.
2.2.2. Replacing legs
- Place unit on its back carefully so that the hinge is not damaged.
- Dismount outer legs by unscrewing 2-2 screws. (Fig. 12)
- Take out inner legs from outer legs. (Fig. 13)
- Mount inner legs by securing them using bores further apart from each
other. (Fig. 14)
- Screw remaining screws into appropriate bores, fasten.
- Set aside the outer legs (possible re-mounting).
- Place the refrigerator on its legs.
Figure 10 Figure 11
Figure 12 Figure 13
Figure 14