Service manual

7
2.2.3. Replacing cowl
- Turn cabinet onto door using appropriate protection support.
- In case of curved door use support on both sides to avoid oscillation
(cardboard support).
- Unscrew the screw that secures cowl, while keeping the end of cowl from
folding down. (Fig. 15, 16)
- Lastly, remove screw next to boiler insulation.
(mounting ease) (Fig. 17)
- Lift up cowl, then put replacement part in place.
- Fasten screws starting with the screw next to boiler insulation, while
holding the unfastened end of cowl with your hand.
- Tighten screws. While fastening, check the leveling of cowl and plate.
Adjust as necessary.
2.2.4. Replacing lock
”Snap lock” model
- Open door.
- Pull down rosette using 2 standard screwdrivers. (Fig. 18)
- Pop up lock cover:
With the bolt in locked position, pull the rim of lock cover onto the bolt
using a standard screwdriver to keep it from snapping back. (Fig. 19)
Snap off lock cover lid using 2 standard screwdrivers. (Fig. 20)
Figure 15
Figure 16 Figure 17
Figure 18
Figure 19 Figure 20