Service manual

8
- Unscrew securing screws. (Fig. 21)
- Pull out lock. (Fig. 22)
- Reassembly is done in reverse order.
- Rosette and lock cover lid should be snapped in place applying slight
pressure.
When popping the lock cover lid open, the bolt must be in locked position.
”Turn lock” model
- Open door.
- Pull down rosette using 2 standard screwdrivers.
- Unscrew securing screws.
- Pull out lock toward door lining.
- Push new lock in lock bore of door.
- Reinsert and tighten securing screws.
- Push rosette in place applying slight pressure.
2.2.5. Replacing door panel
- Replacement of the door panel should be done with the door detached and
the lock dismounted.
- Remove door shelves. They can be removed by lifting the shelves.
- Place door – with door lining down – on protective support.
- Unscrew screws that secure locking-panel. (Fig. 23)
- Lift locking-panel from its nest. (Fig. 24)
- Pull out door panel. (Fig. 25)
Figure 21 Figure 22
Figure 23
Figure 24
Figure 25