Service manual

9
- Adjust foil lining.
- Place the the door panel up to the handle lath into groove on one side of
door.
- Slightly bend door panel. (Fig. 26)
- Snap door panel into place in groove on other side of door.
- Push door panel until cylindrical bores on the plate and on the door are
concentric. (Fig. 27)
- Insert locking-panel, secure with screws.
- Reinstall lock.
- Reinstall door.
2.2.6. Replacing freezer door
- Open refrigerator door.
- While the freezer door is shut, insert a standard 4*100 screwdriver
between the freezer’s top door mount and the freezer door, with slight
pressure lift the top door mount pin out from its bore. (Fig. 28)
- Tilt and remove the freezer door by a quick pull on the upper edge of the
freezer door. (Fig. 29)
- Lift out the freezer door from the bottom door mount bore, then remove the
bottom hinge pin from the freezer door bore. (Fig. 30)
- Insert the hinge pin into the bottom bore of the new freezer door. (Fig. 31)
- Insert the freezer door with the pin into the freezer’s door mount bore so
that the bolt secures the freezer door. (Fig. 32)
- Inserting a standard 4*100 screwdriver between the freezer door and the
upper freezer door mount, bend the freezer door mount upwards.
- Applying slight pressure on the upper part of the freezer door, snap the top
door mount pin in place. (Fig. 33)
Figure 26 Figure 27
Figure 28 Figure 29 Figure 30