User manual

ManualsBrandsDometic ManualsDomestic AppliancesNDE1402

3. REPLACING A HALOGEN LAMP

TROUBLESHOOTING

The Refrigerator Does Not Cool Properly

A. Check level of refrigerator.

B. Venting problem.

Restriction in air flow across cooling unit.

C. Heavy frost buildup on evaporator fins.

Defrost.

D. Improperly set thermostat.

(See section Operating Instructions, part Start Up

Instructions.)

E. FUSES

1. Refrigerator AC Supply.

2. Control system. See page 11, part Fuses.

If the refrigerator fails to work, check the following

points before calling a service technician:

• that the fuses are intact

• that the power cord is plugged in

• that 12 volt DC is connected to the refrigerator

The refrigerator is equipped with an overheating protec-

tion.

An authorised service technician can check if it has been

triggered or not.

NOTE: AVOID SPRAYING WATER THROUGH THE

REFRIGERATOR VENTS WHILE WASHING YOUR RV.

All the above instructions are to be followed closely. The

refrigerator is quality-guaranteed. However, we are not

responsible for any failures caused by improper adjust-

ments and unfavorable installation conditions. Contact

service point or distributor service dept. for assistance.

! CAUTION

Turn off the refrigerator before replacing the lamp.

Wear gloves as protection against hot lamp, broken

glass and as protection of the new lamp.

Refrigerator

The lamp is located at the top of the refrigerator com-

partment.

To replace the lamp proceed as follows:

• unhook the tab on the lamp cover by pressing in

with the thumb on the side of the lamp cover.

• remove the lamp cover.

• with gloves, pull out the lamp from the socket and

replace it with a new 12V, 10-watt halogen lamp

base G4.

• replace the lamp cover by placing the two tabs into

the corresponding slots of the lamp house and

press the tab into place.

Freezer

The lamp is located on the right side of the freezer com-