User manual

CERTIFIED INSTALLATION

Certified installations require one roof vent and one lower

side vent.

For “Certified Vent System Kits” see page 13.

For further information contact your dealer or distributor.

METHODS OF INSTALLATION

The method of installation is shown in FIG. 9. It is essen-

tial that all maximum or minimum dimensions are strictly

maintained as the performance of the refrigerator is de-

pendent on adequate flow of air over the rear of the re-

frigerator.

NOTE: The upper vent should be centered over the

condenser coil at the back of the refrigerator.

VENTILATION HEIGHTS

CLEARANCES

Minimum clearances in inches to combustible materials

are:

G: Top 0

K: Side 0

L: Bottom 0

M: Rear 0

N: See NOTE: Clearance “N” below.

NOTE: Clearance “M” is between the rearmost part of

the refrigerator and the wall behind the refrigerator.

NOTE: Clearance “N” is the distance between the bot-

tom of the lower vent to the roof material. For ventilation

height, see table VENTILATION HEIGHTS

See Figures 9, and 10.

LOWER VENT CUTOUT

13-5/8”

28-5/8”

FIG. 9

Ventilation

height

Condenser

FIG. 10

Installation with roof Minimum ventilation

vent and lower side vent heights in:

Refrigerator Inches mm

NDE 1402 69-1/8 1756

NOTE: Wood Strip

MUST be in place