Operation Manual

DO8139

www.domo-elektro.be

FASTENING THE GRILL AND THE FAN BLADES

Remove the spinner from the motor drive (or remove it from the packaging). Loosen

the plastic screw from the motor drive. Position the grill behind the motor drive and

use the plastic screw to fasten the grill. (Fig. 1)

Place the fan blades on the motor drive. Make sure the pin on the motor drive ts

perfectly behind the fan blades (Fig. 2). Use the spinner to fasten the fan blades on the

motor drive.

Position the front grill on the rear grill and fasten them together with the help of the

attaching clip. Finally, use the screw at the top of the rear grill to fasten both halves of

the grill together rmly. (Fig. 3)

INSTRUCTIONS

Speed regulation with the help of the 4 buttons on the control panel.

0: off

1: low speed

2 : medium speed

3: high speed

To allow the fan to oscillate, push in the oscillation button. To stop the fan from

oscillating, pull the button up.

To direct the ventilation up or down, push down or pull up gently on the grill to adjust

the direction up or down.

MAINTENANCE

This fan requires very little maintenance. Never try to repair the fan yourself. If it is

defective, have it checked and/or repaired by a qualied person.

Prior to assembling the fan or cleaning it, remove the plug from the outlet.

Keep the rear grill free of dust and other substances in order to allow free circulation

of the air around the motor. Do not disassemble the fan to remove dust from the motor.

You may clean the exterior of the machine with a soft moist cloth and a mild

detergent. Carefully dry the machine afterwards.

Never use corrosive or abrasive products to clean the machine.

Make sure that no water gets into the motor of the machine.