Installation Instructions

9. Connect the cable to the GEOTAB device using this side of the cable.
10. Place zip tie around GEOTAB device to hold cable in place.
Note how the zip tie fits in the groove.
11. Find a secure location to mount the receiver. Make sure that the
cable can reach the GEOTAB GO device.
• Do not install the receiver in a metal box. Keep it in the open as
much as possible.
13. Insert the other end of the cable into receiver.
• Make sure the connector latches when inserted by slightly
tugging on the cable once attached. Supplemental IOX cables
may be required to connect multiple devices to a single IOX
port on a GEOTAB device. Contact your GEOTAB sales
representative to get the correct cable.
Receiver