User's Manual
2
W320折叠无线充说明书
日期：2022-05-25 比例：1:1
版本：A0
3-In-1 Charging Station
User Manual
Product Components
Smartwatch
Wireless Charger
Lightning Connector
for Headphones Charging
Lightning Connector
for Smartphone Charging
Product Model: W320
Input : 5V/3A
Output : 10W for Smartphone
5W for Headphones
3W for Smartwatch
F
requency ：325KHz
1. The LED indicator lights turn green, finally turning o
after 5 seconds, which indicates that it has entered
the standby state.
2. The LED indicator light turns blue, indicating the
corresponding device is charging, and the blue light
turns o after 20 seconds.
1. Smartphone
2. Smartwatch�
3. Headphones
iPhone6/iPhone6Plus/iPhone6s/iPhone6sPlus/
iPhone7/iPhone7Plus/iPhone8/iPhone8Plus/iPhoneX/
iPhoneXS/iPhoneXSMax/iPhoneXR/iPhone11/
iPhone6/iPhone6Plus/iPhone6s/iPhone6sPlus/
iPhone7/iPhone7Plus/iPhone8/iPhone8Plus/iPhoneX/
iPhoneXS/iPhoneXSMax/iPhoneXR/iPhone11/
iPhone11Pro/iPhone11ProMax/iPhoneSE2/iPhone12/
iPhone12mini/iPhone12Pro/iPhone12ProMax/iPhone13/
iPhone13mini/iPhone13Pro/iPhone13ProMax
Two Ways to Start Smartwatch Charging:
Two Steps to Start Headphone Charging:
Two Steps to Start Smartphone Charging:
① Lift the wireless charger upwards to stand up.
② Or push the bottom upwards with your finger.
③ Lift the lightning connector up with your finger.
④ Adjust the position to keep the connector vertical.
⑤ Lift the lightning connector up with your finger.
⑥Adjust the position to keep the connector in place.
Three Steps to Use the Phone Stand：
Tips:
⑦ Press the red area to lift the phone stand a little.
⑧ Use the finger to lift it and find a supporting angle.
⑨ Finally, insert the stand into the slot for stabilization.
1. Before charging, please get the stand in place first,
then place your phone on the stand and readjust the
lightning connector for charging.
2. Lift the stand and lay it down, back to the original
position when not using it.
Please pay attention to the following issues.
Otherwise, it may cause abnormal charge, high
temperature, intermittent charging issue, or that it’s
even not charging at all.
1. Please put the device at the center of the charging
area to ensure stable charging for your smartwatch.
2. The watch charger comes with overheat protection.
When the temperature reaches 40 degrees Celsius,
it will stop charging automatically and continue
charging when it is back to normal.
3. Do not put the cases made of metal or
attachments such as magnets, cards, and grips
around the devices, which will interfere with charging.
4. The lower the ambient temperature is, the faster
the charging speed is. So the charging speed is much
faster in winter than that in summer.
5. Do not charge your devices under high temperature
or humidity to avoid circuit damage.
6. Keep out of reach of children to avoid unnecessary
accidents.
Apple Watch1/2/3/4/5/6/SE/7
AirPods 1/2/3/Pro
Charging Status
Indicator Lights
尺寸：65*85mm
提示：
印刷：折页
Model No: W320
18W
2 3 4
65 7 8
Charging Indicator
Compatible Devices
Product Specifications
Notes
Any Changes or modifications not expressly approved
by the party responsible for compliance could void the
user's authority to operate the equipment.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation.
This equipment generates uses and can
radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and
receiver.
-Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV
technician for help.
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with
minimum distance 20cm between the radiator & your
body.
8
5
9
3
1
7
4
Operation Instruction
FCC warning