Installation Guide
Traditional & Classic Door Canopy Assembly and Mounting
1.
Installing the head rod clamps, spacing evenly starting 6" from
each end of the door
a)
Drill pilot or anchor holes for each head rod clamp.
b)
Fasten both head rod clamps to the wall, use a level to ensure
clamps will be level with each other and centered above door or
opening.
Door
1.
Assemble the Head Rod bar using the internal connector.
a)
Slide the Head Rod bar into the head rod pocket (see below).
2.
Attach the Head Rod bar into the Head Rod clamps (already mounted on
wall) and tighten the wing nuts.
3.
Assemble the Front bar using the internal connector.
a)
Slide the front bar into the front bar pocket. (located near the valance
of awning)
4.
Add the elbows to the ends of front bar.
5.
Screw the Eye end onto the Arm (repeat on other arm).
a)
Slide the Arms into the side pocket of door canopy.
b)
Screw into the elbows on front bar.
G
N
N
6.0"
6.0"
D
D
D
D
D
A
A
I
F
I
F
K
K
E
K
C
J