Operating instructions

MODEL 400 WOODSTOVE
5-98 15 72308B
D. STEP BY STEP INSTALLATION OF THE WOODSTOVE
1. ASSEMBLY.
Before assembly, place the unit near the final
position, then follow the procedures below.
a. Open the stove and remove all the parts and arti-
cles packed inside. Inspect all the parts and the
cast iron body for shipping damage. Contact your
dealer if any irregularities are noticed.
b. Install floor protection if the heater is being placed
on a combustible floor. Refer to the section on
floor protectors for required materials and sizes on
page 6.
c. Lift the unit upright and place it into position on the
floor protector. DO NOT TILT THE UNIT ON THE
ON THE CAST IRON LEGS.
d. The Flue Collar is located inside the Model 400.
For a top flue exit, attach the Collar to the top of
the heater with the bolts and nuts provided. Fur-
nace cement may be used to seal under the
Collar. See Figure 17.
Should a rear flue exit be necessary, you will
need to remove the center section from the back
shield to allow for rear exit. The Flue Collar is
then fastened to the back of the unit with the
bolts and nuts provided, as shown in Figure 17.
Install the cast iron Cover Plate on the top of the
heater in the unused Flue Opening by placing a
bead of furnace cement around the edge and
place the Cover in position so it sits firmly
against the cast iron. Attaching the Cover Plate
to the rear of the stove, you will also need to
attach the Fixing Bar to the Cover Plate with the
washers provided. See Figure 17 for Top and
Rear Cover Plate installation.
Figure 17
Top and Rear Cover Plate Installation