Product data

INSTRUCTIONS CM271A
© Panduit Corp. 2004
FOR TECHNICAL SUPPORT CALL: 866-405-6654
Page 1 of 2
OPTICOM™ Fiber Optic Rack Mount Enclosure
Part Numbers: FRME3, FRME4
DISCARD
DISCARD
FRME Enclosure Parts
Caution Label
Laser Warning Label
Grommet
GROMMET CUTTING DIAGRAM
Cut the small
circle for 1”
diameter
innerduct
Cut the large
circle for 1-1/
2” diameter
innerduct
Cut the straight
lines when not
using any inner-
duct
FRME3
1 FRME Enclosure
1 FRME Kit
1 Port I.D. Label
2 EIA Enclosure Brackets
FRME4
1 FRME Enclosure
1 FRME Kit
1 Port I.D. Label
2 EIA Enclosure Brackets
Assembly Instructions:
1. Determine the cable entry location on the enclosure.
Remove the knockout by inserting a screwdriver into
the slot located in the center of the knockout and apply
a twisting upward motion then lift out. Insert grommet
following proper cutting diagram. Snap in saddle clips.
Grounding Lug attaches to a stud at the rear, inside the
enclosure on the top or bottom with a #10-32 nut. Apply
Laser Warning Label and Caution Label in a clearly
visible location. Apply Port I.D. Label (s) on the inside
of the door.
Port I.D. Label
Saddle Clip
Grounding Lug
Mounting Bracket